![]() left, right, top and bottom parameters specify four sides of the subplots’ positions. They are the fractions of axis width and height, respectively. ![]() wspace and hspace specify the space reserved between Matplotlib subplots. The answer from Constantin is spot on but for more background this behavior is inherited from Matlab. We can use the plt.subplotsadjust () method to change the space between Matplotlib subplots. Alternative form for addsubplot (111) is addsubplot (1, 1, 1). This can be of course adjusted further with something like subplots_adjust(). For example, '111' means '1x1 grid, first subplot' and '234' means '2x3 grid, 4th subplot'. Nrows=9, ncols=9, sharex=True, sharey=True, figsize = (8,8)Īxes.remove() #remove Axes from figĪxes = None #make sure that there are no 'dangling' references. In the example below I go with the latter. Of course, if you set up a grid of 9x9 subplots, that gives you more plots than you want, but you can either make the redundant plots invisible (for instance with t_visible or remove them entirely. For a grid of equally-sized subplots, this is easily automated with the sharex and sharey keywords of plt.subplots(). Is there a better way to get proper spacing between subplots while still maintaining aspect ratio and a large enough subplot size? The only possible solution I could come up with was to use subplots_adjust() with a larger figsize, but this results in a very large space between the edges of the figure and the subplots.Īs all your axes have the same x and y ranges, I would choose to show the tick labels only on the outer Axes. However the subplots appear too small to adequately convey information. The result is almost correct, and with a little more tweaking the space between subplots would be perfect. Below is the figure with subplots_adjust(hspace=1.0, wspace=1.0). Instead of using tight_layout(), I figured I should just adjust the subplots manually using subplots_adjust(). ![]() But as can be seen in the figure below, tight_layout() squeezes the width of the plots unacceptably: Of course the spacing between subplots is unsatisfactory so I did what I usually do and used tight_layout(). This is the result without any modifications: ![]() Here is the minimal working example: import matplotlib.pyplot as plt I am currently trying to plot many subplots in Matplotlib (Python 3.6, Matplotlib 2.0.0) using GridSpec. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |